franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Fri Jul 02, 2004 12:46 pm Post subject: How To Calibrate a Renishaw Probe's Tool Length |
|
|
This program uses two variables, #537 and #538, to position the probe in X and Y and then calibrates the probe's tool length. An approximate tool length Offset must be entered for the probe before running this program. Using variables to position the probe makes the program very flexible. Simply move the machine to the point where you want to touch the stylus and look at the position display. Enter these values for #537, #538 and run the program. You will need to edit T60 to match the tool number of your probe.
Code: | %
O9102
(SET PROBE TOOL LENGTH)
(#537=X POSITION TO TOUCH)
(#538=Y POSITION TO TOUCH)
G0G91G30Z0
G0G91G30Y0
T60T0M6
#5203=0(CLEAR COMMON Z)
G0G90G54X#537Y#538
G65P9810Z2.0F200.0
G65P9801Z0T24
G65P9810Z2.0F200.0
G0G91G30Z0
G0G91G30Y0
M30
% |
|
|