mistux Site Admin
Joined: 25 Jun 2004 Posts: 1042 Location: South Bend, Indiana USA
|
Posted: Mon Nov 20, 2006 11:30 am Post subject: Loading a CNC Program into a Fagor 8025TG |
|
|
Loading a CNC Program into a Fagor 8025TG
1. Push the OP MODE button.
2. Push the 6 button for Editing.
3. Push the F2 or PR.SEL soft key.
4. Type 7000 and push the F1 or CONTIN soft key.
5. Push the Down Arrow to N99 is displayed.
6. Type F.xxxx and push the ENTER button for the appropriate program.
7. Push the OP MODE button.
8. Push the 7 button for Peripherals.
9. Push the 3 button for Send to General Device.
10. Type 7000 and push the ENTER button.
11. Push the F1 or CONTIN soft key.
12. Push the 2 button for Receive from General Device.
13. Type xxxx for the desired program.
14. Push the ENTER button.
15. The desired program will be sent within 5 seconds.
NOTE: If you get an 07001 program instead of your desired program, double check 07000 and verify the desired program number or filename and repeat the procedure.
Example of a Remote Request program to request the file 1234:
Code: | %07000
N10 (PREDATOR DNC)
N99 F.1234
N100 M30
|
|
|