Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Hardinge RR procedures

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
juniorf
Frequent Poster


Joined: 15 Jun 2006
Posts: 29
Location: Little Rock, AR

PostPosted: Fri Aug 11, 2006 3:52 pm    Post subject: Hardinge RR procedures Reply with quote

2750

1. Mode Edit
2. Edit Key off
3. Hit left arrow until directory listing appears
4. Hit Program key until the Directoy listing shows
5. Enter 08888
6. Press the right arrow key until you see Back Edit in blue displayed (if BG_EDT End shows in green then hit it until Back Edit shows)
7. Press the Left arrow key
8. Press the Program key
9. Arrow down until you get to the GET line
10. Type the entire line over supstituting your file name after the GET. Example: (GET HA120.T)
11. Hit Alter
12. Hit Right arrow key
13. Hit Punch
14. Hit This soft key (if you don’t see “This” then right arrow until Punch is displayed, then hit Punch softkey again and then “This”)
15. wait 20 seconds
16. Hit Read softkey
17. Hit All softkey
18. Program will appear in a few minutes.


==================

2611

1. Yellow Edit button
2. Edit key off
3. Program button
4. LIB softkey
5. Enter O8888
6. Hit white arrow down button
7. Hit white arrow down button to select the N100 line
8. Type entire line in make sure you hit the EOB key
9. Hit Alter button
10. Hit white arrow down button
11. Hit the Delete button to delete the data that got moved to the next line
12. Hit right Arrow soft key (on Monitor)
13. Hit Punch softkey
14. Hit Exec softkey
15. Hit Stop softkey
16. Wait 30 seconds
17. Hit Read softkey
18. Hit Exec softkey
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group