Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

OT Macro help

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming
View previous topic :: View next topic  
Author Message
BillyB
Frequent Poster


Joined: 27 Jul 2005
Posts: 60
Location: Lexington, KY, USA

PostPosted: Fri Feb 17, 2006 3:44 pm    Post subject: OT Macro help Reply with quote

WHEN I PUSH THE EOB KEY IN A NUMBER OF TIMES ALL I GET TO SHOW IS ; , / AND NO #. The macro pages show up (100s and 500s) but I can not load a program with the # in it.
_________________
I'd rather be making chairs.
Back to top
View user's profile Send private message Send e-mail
JoeM
Master Poster


Joined: 09 Jul 2004
Posts: 122
Location: Jackson Hole, Wyoming USA

PostPosted: Fri Feb 17, 2006 3:45 pm    Post subject: Reply with quote

OT series do not support keypad entry of the # character. You'll need to prepare the subprogram/part program with all necessary # entries on a PC/laptop and then upload it to the machine.
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group