John_B Frequent Poster
![](images/avatars/gallery/College/southernillinois3.gif)
Joined: 03 Jul 2004 Posts: 56 Location: Milwaukee, WI USA
|
Posted: Sat Dec 03, 2005 6:14 pm Post subject: Fanuc 3M DNC operation |
|
|
Hi,
we recently acquired a kitamura machining center with a Fanuc 3M model C controller. I'm presently trying to configure it to be able to do DNC operation but the only way i could find was the upgrade offered by www.memex.ca.
Can any1 tell me if there's any other way of doing this?
From what i understand, Fanuc 0M and Fanuc 6M can do DNC, what's up with Fanuc 3M? |
|