View previous topic :: View next topic |
Author |
Message |
JoeM Master Poster
Joined: 09 Jul 2004 Posts: 122 Location: Jackson Hole, Wyoming USA
|
Posted: Sat Dec 03, 2005 6:18 pm Post subject: Okuma LC-10 1980 OSP3000 Display problems, tips ? |
|
|
Hi,
I have Okuma LC-10 1981 with OSP3000. Problem is that programming display doesn't work. All error lights are on and those works (on display). But as said programming display doesn't work.
All movements and programs works.
Does anybody have tips what could I check ? _________________ Thanks.
===================
I would rather by Fly Fishing! |
|
Back to top |
|
|
franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Sat Dec 03, 2005 6:19 pm Post subject: |
|
|
Check for power at the plug behind the screen (usually a 3 pin plug). If power is present then replace screen. |
|
Back to top |
|
|
hsimola New Member
Joined: 17 Feb 2006 Posts: 2
|
Posted: Mon Feb 20, 2006 2:24 am Post subject: |
|
|
I have exactly similar problems, did you found help for this ?
Or does anybody else have tips what should I try ? |
|
Back to top |
|
|
hsimola New Member
Joined: 17 Feb 2006 Posts: 2
|
Posted: Thu Feb 01, 2007 4:04 am Post subject: Okuma LC-10 1981 with OSP3000 |
|
|
Hello!
I have Okuma LC-10 1981 with OSP3000 programming unit. It have been broken 4 years.
I have problem with programming display, check attached picture IMG_01016_1.jpg.
Everything else work except programming display and it led number display.
Could you please give advices what to try or which part I should replace? do you have spares?
There goes 2 wire sets to display board, when I remove both and set control ON, then some of leds are ON.
Does anybody have only "E4809-032-399-C" board? and what would be price for it?
Harri |
|
Back to top |
|
|
|