View previous topic :: View next topic |
Author |
Message |
BillyB Frequent Poster
Joined: 27 Jul 2005 Posts: 60 Location: Lexington, KY, USA
|
Posted: Tue Nov 01, 2005 9:34 pm Post subject: Miyano Live-Tool |
|
|
I'm having trouble getting X-axis to feed when using revolving tool. Machine will rapid to position fine, but when I program in an x-axis feed move (G1 X-.06 F1.0), machine will stop and read no further. No errors, just the run light and no movement. Fanuc OT control. Any suggestions?
Current Program:
Code: | T0606 (Live Tool)
S2000 M43 (Start revolving tool spindle)
G0 H-4.375 (Position Sub-Spindle)
G0 Z0
G0 X.100
G1 X-.06 F1.0 (Feed X-axis)
G0 X.100
G28 U0
G28 WO
G28 H0
M30 |
_________________ I'd rather be making chairs. |
|
Back to top |
|
|
John_B Frequent Poster
Joined: 03 Jul 2004 Posts: 56 Location: Milwaukee, WI USA
|
Posted: Tue Nov 01, 2005 9:36 pm Post subject: |
|
|
You need to go into IPM feed mode (Inch per minute) Should be G98 but check your manual.
G98G1X0F10. |
|
Back to top |
|
|
BillyB Frequent Poster
Joined: 27 Jul 2005 Posts: 60 Location: Lexington, KY, USA
|
Posted: Tue Nov 01, 2005 9:37 pm Post subject: |
|
|
That did it, thanks _________________ I'd rather be making chairs. |
|
Back to top |
|
|
|