View previous topic :: View next topic |
Author |
Message |
franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Tue Nov 01, 2005 9:09 pm Post subject: Fanuc M55-Code |
|
|
I came across an old nc program for a Fanuc 0T control on a LeBlond lathe. One of the first blocks in the program has an M55 command.
This M-code is not listed in my Fanuc control manual, and I can't seem to find any info on it. Does anyone know what M55 does on a Fanuc 0T control? _________________ --------------------------
Thanks for everything. |
|
Back to top |
|
|
dawn Master Poster
Joined: 26 Jun 2004 Posts: 311 Location: Mishawaka, IN
|
Posted: Tue Nov 01, 2005 9:11 pm Post subject: |
|
|
I did some digging and found the some info, it turns out M51 thru M57 are for setting headstock into 1st gear, 2nd gear, etc. Then each gear has a max rpm for spindle speed. _________________ Dawn Mitchell
Manufacturing Information Solutions
www.mis-group.com |
|
Back to top |
|
|
franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Tue Nov 01, 2005 9:12 pm Post subject: |
|
|
Thanks |
|
Back to top |
|
|
|