BillyB Frequent Poster
Joined: 27 Jul 2005 Posts: 60 Location: Lexington, KY, USA
|
Posted: Fri Jul 29, 2005 5:41 pm Post subject: Entering Program At Fanuc 6M Control |
|
|
We have Fanuc 6M CNC controller. We wish to enter new part program in the system by address key board. Kindly know the steps how to enter new program. We have only one small program in the machine. |
|
JoeM Master Poster
Joined: 09 Jul 2004 Posts: 122 Location: Jackson Hole, Wyoming USA
|
Posted: Fri Jul 29, 2005 5:42 pm Post subject: |
|
|
Here's the procedure to enter this short program:
O1234 ;
N1 G91 G28 Z0 ;
N2 G28 X0 Y0 ;
N3 M30 ;
1) Select EDIT mode on the mode select switch
2) Turn OFF the memory protect key switch
3) Press the PRGRM key to display the program screen
Key in the letter "O" and the number "1234", then press the red INSERT key
Press the EOB key, then press INSERT
N1 then INSERT
G28 INSERT
Z0 INSERT
EOB key, then INSERT
N2 INSERT
G28 INSERT
X0 INSERT
Y0 INSERT
EOB key, then INSERT
N3 INSERT
M30 INSERT
(You're done. The Fanuc will put the "%" at the end automatically)
==========
Once a program is entered in EDIT mode, you must then switch to MEMORY mode, turn on the memory protect switch, then press CYCLE START. There are many other machine conditions that can prevent cycle start from happening, but these things are all specific to each machine. _________________ Thanks.
===================
I would rather by Fly Fishing! |
|