Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Haas--Engraving Error Message

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming
View previous topic :: View next topic  
Author Message
JamieR
Frequent Poster


Joined: 30 Jun 2004
Posts: 54
Location: Chicago

PostPosted: Fri Apr 29, 2005 5:29 pm    Post subject: Haas--Engraving Error Message Reply with quote

Q. I’m using G47 to engrave serial numbers, but I’m getting error message number 529: “Illegal G65 parameter. The addresses G, L, N, O, and P cannot be used to pass parameters.” What can I do to fix this? Here’s my program.

G47 P1.0 (5001) X0.5 Y0.75 J0.125 R0.05 Z-0.005 F25.0 E10.0


A. You need to take the decimal point out of the P command – in this case, P is an instruction (Engrave Sequential Numbers) rather than a value, so “P1” is the correct form of the command.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group