JamieR Frequent Poster
Joined: 30 Jun 2004 Posts: 54 Location: Chicago
|
Posted: Fri Apr 29, 2005 5:29 pm Post subject: Haas--Engraving Error Message |
|
|
Q. I’m using G47 to engrave serial numbers, but I’m getting error message number 529: “Illegal G65 parameter. The addresses G, L, N, O, and P cannot be used to pass parameters.” What can I do to fix this? Here’s my program.
G47 P1.0 (5001) X0.5 Y0.75 J0.125 R0.05 Z-0.005 F25.0 E10.0
A. You need to take the decimal point out of the P command – in this case, P is an instruction (Engrave Sequential Numbers) rather than a value, so “P1” is the correct form of the command. |
|