Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Extended Edit Option?

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
CNCJimmy7
Frequent Poster


Joined: 05 Jul 2004
Posts: 91
Location: Minneapolis, MN
PostPosted: Fri Mar 18, 2005 12:56 pm    Post subject: Extended Edit Option? Reply with quote
I was curious if anyone could tell me if extended edit is an option on a Fanuc 16 control.Is it just a parameter setting?

And if it is, does anyone know the parameter #.
Back to top
View user's profile Send private message Send e-mail
JoeM
Master Poster


Joined: 09 Jul 2004
Posts: 122
Location: Jackson Hole, Wyoming USA
PostPosted: Fri Mar 18, 2005 12:58 pm    Post subject: Reply with quote
9936 bit 7 is extended part edit for all i controls

This inculeds 16/18/21 i/a/b/c
_________________
Thanks.
===================
I would rather by Fly Fishing!
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group