Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Fanuc OT ROM parity

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
CNCJimmy7
Frequent Poster


Joined: 05 Jul 2004
Posts: 91
Location: Minneapolis, MN
PostPosted: Thu Mar 17, 2005 11:19 pm    Post subject: Fanuc OT ROM parity Reply with quote
I have an alarm that states 998 ROM Parity on the screen when the controller is turned on.

Any one have an idea what this could be
Question
Back to top
View user's profile Send private message Send e-mail
JoeM
Master Poster


Joined: 09 Jul 2004
Posts: 122
Location: Jackson Hole, Wyoming USA
PostPosted: Thu Mar 17, 2005 11:20 pm    Post subject: Reply with quote
Definitly have a bad mem. card especialy if it is a 0C control. make sure and pull off your old eproms off your old board to put on the new, they have your ladder and param. etc.
_________________
Thanks.
===================
I would rather by Fly Fishing!
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group