Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Parameters to enable type II canned cycles

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
franke
Master Poster


Joined: 26 Jun 2004
Posts: 161
Location: Indiana, USA
PostPosted: Thu Mar 17, 2005 10:19 pm    Post subject: Parameters to enable type II canned cycles Reply with quote
I need to know the parameters to enable type II canned cycles (aka. pocket roughing) on Fanuc series 18T and 21T

I also wouldn't mind knowing how to enable the Custom Macro programming language as well.
_________________
--------------------------
Thanks for everything.
Back to top
View user's profile Send private message
CNCJimmy7
Frequent Poster


Joined: 05 Jul 2004
Posts: 91
Location: Minneapolis, MN
PostPosted: Thu Mar 17, 2005 10:24 pm    Post subject: Reply with quote
On our Fanuc 0M they are:

901 bit 5 chamferring, corner R
902 bit 6 custom macro A
913 bit 7 custom macro B
923 bit 2 G71 type 2
================
GE Fanuc 21i - t G71 type 2

9944b7=type 2 canned cycles
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group