mistux Site Admin
Joined: 25 Jun 2004 Posts: 1042 Location: South Bend, Indiana USA
|
Posted: Thu Sep 11, 2008 1:11 pm Post subject: DNC / file transfer settings for Okuma OSP7000 |
|
|
Set the following parameters on the machine:
Optional Parameter (bit) Value
#1 00011011
#8 10101010
#12 10100010
Optional Parameter (word) Value
#1 0
#39 9600
#54 1
To set the CNC up for drip feed:
Drip feed on this control is an optional extra, see the Okuma manual for instructions.
--------------------------------------------------------------------------------
Set ConnectCNC as follows:
Common Settings
Name Okuma 7000
Baudrate 9600
Data bits 7
Stop bits 2
Parity Even
Flow control Xon/Xoff
Xon Char. 17
Xoff char. 19
Port as available
Each file should begin with "$filename.MIN%" (without the quotes), and end with "%". I think the first character after the $ has to be a letter not a number. |
|