View previous topic :: View next topic |
Author |
Message |
franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Sun Jul 04, 2004 10:21 pm Post subject: Macro or Sub Program ? |
|
|
I have Monarch VMC with a fanuc 16 control.There is a rotary table that is mounted normal to the bed.I would like to make a X-Y cut,then rotate the table 3Deg. and make the same cut again.Continue (120 times) around the entire part.
Do I need a macro or sub program to do this _________________ --------------------------
Thanks for everything. |
|
Back to top |
|
|
dawn Master Poster
Joined: 26 Jun 2004 Posts: 311 Location: Mishawaka, IN
|
Posted: Sun Jul 04, 2004 10:22 pm Post subject: |
|
|
either way could work. if its not so common you could just make a sup program
maybe like this
Code: | T1M6
G0G54X10.Y0M3S2342
G43Z.1
M98P1L120(loop O1 120 times)
G0G91G28Z0
etc.
O1(INDEX SUB)
G98G81X10.Y0Z-.5R.1F20.
G80
G0G91A3.0
G90
M99 |
many ways to do it better than that even _________________ Dawn Mitchell
Manufacturing Information Solutions
www.mis-group.com |
|
Back to top |
|
|
|