Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Write Parameters

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> Fanuc
View previous topic :: View next topic  
Author Message
CNCJimmy7
Frequent Poster


Joined: 05 Jul 2004
Posts: 91
Location: Minneapolis, MN

PostPosted: Mon Jun 04, 2007 3:20 pm    Post subject: Write Parameters Reply with quote

How do I get to set the parameters on a Fanuc? Everytime I try to set it it tells me that I can't.

I think there is a parameter bit that I have to change in order to be able to change any others. Does anyone know what it is?
Back to top
View user's profile Send private message Send e-mail
LindaSimpson
New Member


Joined: 21 May 2007
Posts: 24
Location: Cleaveland, IH

PostPosted: Mon Jun 04, 2007 3:25 pm    Post subject: Reply with quote

You can do the following:

1. Press MDI.
2. Press Settings/Offset button until Settings (Handy) screen is displayed.
3. Move cursor to Parameter Write press 1 then Input, the Alarm 100 will be displayed.
4. Press System button.
5. Press page down to your parameters and make your changes.

This should work on most Fanuc controls.

Remember to go back and turn this off!
________
Glass pipe
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> Fanuc All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group