View previous topic :: View next topic |
Author |
Message |
CNCJimmy7 Frequent Poster
Joined: 05 Jul 2004 Posts: 91 Location: Minneapolis, MN
|
Posted: Mon Jun 04, 2007 3:20 pm Post subject: Write Parameters |
|
|
How do I get to set the parameters on a Fanuc? Everytime I try to set it it tells me that I can't.
I think there is a parameter bit that I have to change in order to be able to change any others. Does anyone know what it is? |
|
Back to top |
|
|
LindaSimpson New Member
Joined: 21 May 2007 Posts: 24 Location: Cleaveland, IH
|
Posted: Mon Jun 04, 2007 3:25 pm Post subject: |
|
|
You can do the following:
1. Press MDI.
2. Press Settings/Offset button until Settings (Handy) screen is displayed.
3. Move cursor to Parameter Write press 1 then Input, the Alarm 100 will be displayed.
4. Press System button.
5. Press page down to your parameters and make your changes.
This should work on most Fanuc controls.
Remember to go back and turn this off!
________
Glass pipe |
|
Back to top |
|
|
|