Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Fanuc 18M Punch Parameters & Offsets

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
mistux
Site Admin


Joined: 25 Jun 2004
Posts: 1042
Location: South Bend, Indiana USA

PostPosted: Wed Nov 02, 2005 12:09 pm    Post subject: Fanuc 18M Punch Parameters & Offsets Reply with quote

To save your Parameters on a Fanuc 18-M do the following:

Parameters: System-->arrow key-->Punch-->All

Offsets: Offsets-->arrow key-->Punch-->"O"-9999-->EXEC (that is the letter O not a zero)

Note sure about tooling, it might be T-9999 from the tooling section.

Of course, use Predator DNC to receive them fromt he machine. www.mis-group.com for more info. Wink
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group