Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Bar puller on Fanuc 18t

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming
View previous topic :: View next topic  
Author Message
franke
Master Poster


Joined: 26 Jun 2004
Posts: 161
Location: Indiana, USA

PostPosted: Tue Nov 01, 2005 9:29 pm    Post subject: Bar puller on Fanuc 18t Reply with quote

Any one know the m code to unclamp spindle for use with a bar puller on fanuc 18t control on ecoca sj25 lathe?

I dont see it listed in the manufactures manual. Any pointers would be greatly appreciated also.
_________________
--------------------------
Thanks for everything.
Back to top
View user's profile Send private message
JoeM
Master Poster


Joined: 09 Jul 2004
Posts: 122
Location: Jackson Hole, Wyoming USA

PostPosted: Tue Nov 01, 2005 9:30 pm    Post subject: Reply with quote

M11 is the one used most for opening the chuck.
_________________
Thanks.
===================
I would rather by Fly Fishing!
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> G-Code Programming All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group