Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Fanuc 0M no Clock or Part count

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls
View previous topic :: View next topic  
Author Message
franke
Master Poster


Joined: 26 Jun 2004
Posts: 161
Location: Indiana, USA
PostPosted: Fri Mar 18, 2005 12:52 pm    Post subject: Fanuc 0M no Clock or Part count Reply with quote
Our VMC with Fanuc -0m controller seems have lost the clock as well as part count display, any suggestions on the parameters to be enabled.
_________________
--------------------------
Thanks for everything.
Back to top
View user's profile Send private message
CNCJimmy7
Frequent Poster


Joined: 05 Jul 2004
Posts: 91
Location: Minneapolis, MN
PostPosted: Fri Mar 18, 2005 12:53 pm    Post subject: Reply with quote
Hey 907.4 will take care of it, I think. Smile
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> CNC Controls All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group