franke
Master Poster
Joined: 26 Jun 2004
Posts: 161
Location: Indiana, USA
|
 Posted: Fri Mar 19, 2010 9:17 am Post subject: How to get to the RS-232 Settings on OSP E100, P200, P100 |
 |
|
OSP-e100l
OSP-P200l
OSP-P100
Here are your key strokes to get to the RS232 page.
First press the Parameter key and place the machine in Parameter mode.
Press Display Change
Cursor down to Option Para: (Read/Write Get/Punch)
Press Close Display.
This should get you to the page needed. If you cant see the page it may not be turned on. To do this after you press the Display Change and bring up your choice box, press the Right Arrow key on the far right of the screen, then press the Menu Change key on the left side of the screen, when the box appears you should see the first one say ALL DISPLAY. If this is not checked then place the check there and close out. This should turn on all your screens.
You can also check the MC User Para: (External Program Select) when in the parameter mode display change box and make sure this is correct. These pages should be pretty much the same for those controls. Hope this helps. |
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
