Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Yasnac MX1 DNC Parameter Settings

 
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> Yasnac
View previous topic :: View next topic  
Author Message
mistux
Site Admin


Joined: 25 Jun 2004
Posts: 1042
Location: South Bend, Indiana USA

PostPosted: Thu Jul 16, 2009 9:45 am    Post subject: Yasnac MX1 DNC Parameter Settings Reply with quote

Set the following parameters on the machine

Change following bits in the parameter #6000 only
bit 7 to 1 (ISO format)

Change following bits in the parameter #6003 only
bit 5 to 1
bit 1 to 1

Change following bits in the parameter #6021 only
bit 6 to 0
bit 5 to 0
bit 4 to 0
bit 1 to 0

Change following bits in the parameter #6022 only
bit 1 to 1
bit 0 to 1

6026 (baud rate) to 0001 1000 (2400)
6028 (baud rate) to 0001 1000 (2400)


Set the following on the PC Serial port tab


Baud 2400
Data bits 7
Parity Even
Stop bits 2

================

If you keep getting an error when the program hits its first line of code. I get "TH Parity Error". Just hit the "IN" button again and and it starts to go in.
Back to top
View user's profile Send private message Send e-mail
Display posts from previous:   
Post new topic   Reply to topic    Manufacturing Information Solutions Forum Index -> Yasnac All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group