View previous topic :: View next topic |
Author |
Message |
dlbnh New Member
Joined: 15 Feb 2006 Posts: 3 Location: Central NH
|
Posted: Fri Feb 17, 2006 1:55 pm Post subject: Macro help needed Yasnac J300M - coordinate rotation |
|
|
Newbie to the group here..Hello all, nice forum. I need some possible examples of a macro to pick points of departure and "skew" (coordinate rotation) when I use a spindle camera for very small features. I'll be picking up 2, 35µm holes about 2.54in apart. One being my X,Y origin and the other defining the angle I must rotate the coordinate sytem to. I would like this to set either my G54 work shift and the "R" value for angle. Then its machining as usual. Any ideas in those brilliant minds I've witnessed here? Thanks in advance _________________ Daryl Boyle
"Repressed somewhere in a small room without windows" Help! |
|
Back to top |
|
|
franke Master Poster
Joined: 26 Jun 2004 Posts: 161 Location: Indiana, USA
|
Posted: Fri Feb 17, 2006 2:18 pm Post subject: |
|
|
What machine and control make and modle are you using? That will make a big difference.
Franke |
|
Back to top |
|
|
dlbnh New Member
Joined: 15 Feb 2006 Posts: 3 Location: Central NH
|
Posted: Fri Feb 17, 2006 2:29 pm Post subject: |
|
|
franke wrote: | What machine and control make and modle are you using? That will make a big difference.
Franke |
Matsuura 510 VMC, Yasnac J300M control. Coordinate rotation option on.
Thanks _________________ Daryl Boyle
"Repressed somewhere in a small room without windows" Help! |
|
Back to top |
|
|
BillyB Frequent Poster
Joined: 27 Jul 2005 Posts: 60 Location: Lexington, KY, USA
|
Posted: Fri Feb 17, 2006 3:43 pm Post subject: Re: Macro help needed Yasnac J300M - coordinate rotation |
|
|
dlbnh wrote: | when I use a spindle camera for very small features. I'll be picking up 2, 35µm holes about 2.54in apart. |
What is a "spindle camera?" |
|
Back to top |
|
|
dlbnh New Member
Joined: 15 Feb 2006 Posts: 3 Location: Central NH
|
Posted: Fri Feb 17, 2006 4:30 pm Post subject: Re: Macro help needed Yasnac J300M - coordinate rotation |
|
|
BillyB wrote: | dlbnh wrote: | when I use a spindle camera for very small features. I'll be picking up 2, 35µm holes about 2.54in apart. |
What is a "spindle camera?" |
I have a Titan scope that mounts in the spindle and I've adapted a CCD camera and monitor so the operator can see the tiny features in a larger scale. Works well http://www.titantoolsupply.com/ _________________ Daryl Boyle
"Repressed somewhere in a small room without windows" Help! |
|
Back to top |
|
|
|