Manufacturing Information Solutions Forum Index Manufacturing Information Solutions
Your Place for Support and Discussions
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Search found 6 matches
Manufacturing Information Solutions Forum Index
Author Message
  Topic: Two Priests and the Statue
Bertolom

Replies: 0
Views: 5881

PostForum: Jokes And Other Funny Items   Posted: Thu Dec 07, 2006 3:45 pm   Subject: Two Priests and the Statue
Two priests are off to the showers late one night. They undress and step into the showers before they realize there is no soap. Father John says he has soap in his room and goes to get it, not botheri ...
  Topic: Man Laws
Bertolom

Replies: 0
Views: 5753

PostForum: Jokes And Other Funny Items   Posted: Thu Dec 07, 2006 3:41 pm   Subject: Man Laws
1. Under no circumstances may two men share an umbrella.

2: It is OK for a man to cry ONLY under the following circumstances:
(a) When a heroic dog dies to save its master.
(b) The moment Angelin ...
  Topic: Speeding in Florida
Bertolom

Replies: 0
Views: 5675

PostForum: Jokes And Other Funny Items   Posted: Thu Dec 07, 2006 3:36 pm   Subject: Speeding in Florida
A Florida senior citizen drove his brand new Corvette convertible out of the dealership. Taking off down the road, he floored it to 80 mph, enjoying the wind blowing through what little hair he had le ...
  Topic: Warner & Swasey Norton 6x18
Bertolom

Replies: 1
Views: 14101

PostForum: Grinders   Posted: Thu Dec 07, 2006 3:34 pm   Subject: Warner & Swasey Norton 6x18
I have one of those and the hardware is very rigid and still going strong. Smile
  Topic: Mitsubishi 520m DNC setup
Bertolom

Replies: 1
Views: 8968

PostForum: CNC Controls   Posted: Wed Dec 06, 2006 12:00 am   Subject: Mitsubishi 520m DNC setup
Found this on the web, so I wanted to put it here.

Machine: Mitsubushi

Communications Settings:

Properties page

Setting Value

DNC-HUB Std PC Ports (or HUB # if installed)
Port Depends ...
  Topic: Drip feed to a Fanuc 6MB
Bertolom

Replies: 1
Views: 10314

PostForum: CNC Controls   Posted: Tue Dec 05, 2006 11:49 pm   Subject: Drip feed to a Fanuc 6MB
The Fanuc controls can load to the machine's memory via the RS232 port. To DNC on the machine, you must use the tape reader (TAPE Mode) on the machine. You can by-pass the reader input and put a BTR ( ...
 
Page 1 of 1
All times are GMT - 5 Hours
Jump to:  


Powered by phpBB © 2001, 2005 phpBB Group